We Don't Sell Equipment; We Engineer Manufacturing Solutions.

A "Class A" finish, characterized by its deep gloss, smoothness, and absence of any defects, is the holy grail of coating. It is only achievable with highly specialized liquid coating equipment and impeccable process control. The process starts with a multi-stage pretreatment process to create a perfectly clean and sealed surface. The application must take place in a climate-controlled, downdraft cleanroom booth to eliminate any airborne dust. Multiple coats—typically a primer, a colored base coat, and a protective clear coat—are applied by precisely programmed robots. Each layer is often partially cured ("flashed off") before the next is applied. Finally, the part is cured in a multi-zone oven that uses a combination of infrared and convection heat to ensure a perfect, smooth flow-out of the clear coat. TIMS specializes in architecting the complex, integrated coating equipment systems required to achieve this pinnacle of surface finishing.

Industry 4.0, or the "smart factory," is transforming coating equipment from a collection of standalone machines into a single, data-rich intelligent system. The new standard, which TIMS integrates into all its lines, involves placing sensors on every critical component—pumps, motors, heaters, robots. These sensors feed real-time performance data to a central controller. This allows for predictive maintenance, alerting you that a nozzle is wearing out before it causes a defect. It enables automated quality control by logging the exact process parameters for every part that is coated. It also allows for remote monitoring and troubleshooting by expert technicians. This integration of data and intelligence is the future, turning coating equipment into a proactive, self-optimizing asset that drives unprecedented levels of quality and efficiency.

Coating wood and medium-density fiberboard (MDF) requires specialized coating equipment due to the material's sensitivity to heat and its porous nature. Traditional powder coating is not viable, but low-temperature UV-cured powder coating systems are an emerging, durable option. More commonly, liquid coating systems are used. A typical automated line for wood products includes sanding robots for surface preparation, a sealed spray booth with a flatline conveyor, and a curing oven that uses infrared or ultraviolet (UV) light. UV curing is particularly effective as it cures the finish in seconds without generating significant heat that could damage the substrate. TIMS designs specialized coating equipment for wood products that provides a beautiful, durable, and consistent finish while carefully controlling the heat to protect the integrity of the material.

High material waste is a significant and unnecessary cost. The solution lies in upgrading to modern coating equipment designed for high transfer efficiency. For liquid paint, this means switching to high-volume, low-pressure (HVLP) or electrostatic applicators that create a soft spray and an electrical charge that wraps the paint around the part. For powder coating, it means using advanced guns that provide superior control over the powder cloud and a high-efficiency recovery system that captures and recycles nearly all overspray. A fully integrated system from TIMS addresses waste at every level, from optimized robotic spray paths to booth designs that maximize recovery, ensuring the vast majority of the coating you buy ends up on your product, not in the waste bin.