The Smartest Investment in Your Product's Long-Term Value.

The pretreatment stage of electrophoresis equipment is evolving. Traditional zinc phosphate processes, while effective, can be complex and produce a significant amount of sludge. The leading-edge technology, which TIMS is an expert in, is "thin film" pretreatment, such as zirconium-based conversion coatings. These systems operate at lower temperatures, have far fewer process steps, and produce almost no sludge, making them much more environmentally friendly and less expensive to operate. They create a nano-thin ceramic layer on the metal that provides excellent adhesion and corrosion resistance. The future of high-efficiency electrophoresis equipment is tied to the adoption of these smarter, greener pretreatment technologies.

Rust and corrosion almost always start in hard-to-reach areas like welds, seams, and internal cavities where traditional spray coatings fail to provide adequate coverage. The most effective and permanent solution to this problem is to use industrial electrophoresis equipment. The E-coating process is not line-of-sight like spraying. Instead, it uses an electrical field that permeates the entire part. This "throwing power" forces the charged paint particles to deposit on every bare metal surface, completely encapsulating the part in a seamless, protective layer. A system from TIMS provides the ultimate defense against this type of corrosion, eliminating the weak points in your finish and drastically reducing warranty claims.

Both E-coating and powder coating can be used as primers, but they have distinct advantages. Powder coating provides a very thick, tough, and chip-resistant layer. However, it is a line-of-sight process and can struggle to provide full coverage in recessed areas due to the "Faraday cage effect." The electrophoresis equipment used for E-coating, on the other hand, excels at providing 100% coverage on complex parts. It creates a thinner but incredibly uniform and corrosion-resistant film. For parts with complex geometries or where ultimate corrosion resistance is the top priority (like a car chassis), E-coat is the superior primer. For simpler parts where mechanical toughness is the main goal, powder may be sufficient.

A typical journey through a TIMS electrophoresis equipment system involves several automated steps. 1. Pretreatment: The part is cleaned and a conversion coating is applied in a multi-stage washer. 2. Electrodeposition: The part is submerged in the main E-coat tank where a DC electrical current applies the paint. 3. Post-Rinses: The part is rinsed in a series of tanks to remove excess, non-adhered paint. This rinse material is recovered and returned to the main tank. 4. Curing: The part passes through a high-temperature oven, which bakes and cross-links the coating to create a hard, durable final film. A sophisticated conveyor system transports the parts seamlessly through this entire process.